Panther PLUS Continuous Access Waste Installation

Continuous Access Waste includes the following:

Solid Waste on the Fly
- Tip Carousel
- TipletDisposable tip within an MTU. Catcher
- Upgraded Waste Drawer
Liquid Waste on the Fly
- Permanent and Removable Liquid Waste Bottles
Universal Fluids on the Fly

Panther Plus can only be installed on Panther Systems Serial #00375 and above.
PCAP Monitor required if installing MTUMulti-tube unit—Container used to process tests in the instrument. An MTU contains five separate reaction tubes. The MTU is moved through the instrument by the linear distributor and includes five tiplets for pipettiing to be used in the mag wash station. Expansion ONLY
Dell XE3
Software v7.x and above
Waste to Drain - drain must be able to handle a minimum flowrate of 1L/min.
Waste to Drain - drain must be 15m (49ft) or less from the Waste to Drain pump.
Waste to Drain - drain must be no higher than 1.2m (3.9ft) from the floor

Panther Tool Kit
CONTINUOUS ACCESS KIT with Full ASSEMBLED WASTE DWR
- Dimensions
  - (82cm x 122cm x 163cm @ 47kg)
  - (32in x 48in x 64in @ 105lbs)
CONTINUOUS ACCESS KIT W/ DWR UPGRADE PARTS
- Tip Carousel with CAN cable
- Tiplet Catcher
- Removable Waste Bottle
- Vacuum Bottle
- Filter Block with Screw
- Vacuum Filter
- Waste Bottle Coupling Block
- Pump Housing
- Vacuum Interface Tubing
- Waste Interface Tubing
- Waste Drawer Y-Splitter CAN Cable
- CAN Extension Adapter
- CAN Jumper
- Waste Bag Sensor Cable Assembly
- Full/Empty Sensor Cable
- Vacuum Bottle Float Sensor Cable Assembly
- 1/4" ID Tubing
- 1/8" RED ID Tubing
- Vacuum Bottle Riser Tubing
- Vacuum Filter Bracket
- Bellows Transfer Pump
- New UFD Drawer labels
Vacuum Grease

Click the

button at the top of the page to send feedback, comments, or change requests.