Verify Vacuum Pressure

1. Power on the Panther System and PC.
2. Log in to the FSE shield.
3. Open the Service Software.
4. Initialize the Vacuum.
5. Activate the Vacuum & Read the Vacuum pressure.
6. Verify the vacuum is within specifications.
   The vacuum level must read between -203mbar and -270mbar and the vacuum pump speed must read above 1650rpm.
   If needed refer to Configuring the Quad Head Vacuum Pump Speed.
7. Exit Service Software.
8. Start Panther Main.
9. Check Vacuum in Panther Main.
10. PrimeOperation of pumping fluid through tubing to ensure proper and consistent fluid delivery (remove air from the tubing, etc.). the system.
11. Verify the Vacuum is within Specification:
    1. Maintains a vacuum level between 6inHg and 8inHg.
    2. Verify that exhaust is flowing through the rear vent (serial #00281 and higher) or through the routed tubing (serial #00280 and lower).
12. Shutdown and restart the Panther System and PC in Customer Mode and return to customer.